
Ultimate construction dehumidifier
For a large open space or a complete new build. This condensation dehumidifier extracts up to 110 litres of moisture a day from the air and is intended for volumes up to about 600 m³. It uses 1.4 kW.
View this unitRebecq lies in the west of Walloon Brabant, in the Senne valley and close to Tubize. Renovate an older house there or build a new one, and screed and plasterwork bring a lot of water indoors. Vernast hires out the construction dehumidifiers, fans and site heaters to get that moisture out again.
RebecqThe right price starts with what needs to dry. For a whole house, wet screed or plasterwork you calculate a complete drying package; for a single room, a single unit may be suitable. Delivery in Rebecq is included in your drying package.
You hire a drying package calculated on the volume, the material and the temperature of your site. The price is known in advance and covers delivery, installation, the moisture reading at the start and at handover, and collection. Not dry within the calculated period? Then the hire continues free of charge, under the terms.

You don't need to combine units yourself. We calculate your drying package based on the floor area, the material and the layer thickness. You see the package price in advance, including delivery to postcode 1430, installation, readings before and after, and collection.
A calculated set-up for your floor, matched to the thickness of the screed. The final reading helps you and your floor layer decide when finishing can start.
More about this dryingConstruction dehumidifiers and fans for even drying throughout the house. We choose the capacity and spread the units over the rooms.
More about this dryingA leak or a flood? Have the cause repaired and standing water removed first. We assess the wet materials and match the drying to them.
More about this drying100% drying guarantee included. Is the material still not dry within the calculated period, despite correct drying conditions? Then you keep hiring the units free of charge, under our drying guarantee terms. This applies to calculated packages that we deliver and install; single units for collection are not covered.
No deposit. The calculator shows your total price and the extras you choose yourself, such as a condensate pump, extra heating or an official moisture report.
Our warehouse in Aartselaar is almost an hour's drive from Rebecq. For Wallonia we work by appointment: you choose a delivery date when you book, and afterwards we set the time together. Delivery, installation and collection are included in the price of the drying package.
A new screed brings more water into a house than most people building expect. How quickly it leaves depends on the thickness, the type of mortar and the temperature in the room. In your request, tell us when the floor was poured or the plaster applied, and we will match the set-up to that.
For when to start, follow the guidelines of your screed contractor or the mortar supplier: some floors must not be force-dried in the first few days. A dry surface is not a dry floor. Have a moisture reading confirm that the core is ready before the tiler or parquet fitter starts.


For a large open space or a complete new build. This condensation dehumidifier extracts up to 110 litres of moisture a day from the air and is intended for volumes up to about 600 m³. It uses 1.4 kW.
View this unit
To keep the air moving. This fan moves 4,500 m³ of air an hour and uses 0.2 kW. That way the moisture leaves the screed faster, but it is the dehumidifier that removes it.
View this unit
For one floor or a medium-sized house. Up to 70 litres a day, suitable for about 400 m³, using 1.1 kW. Two or more units are spread across the closed rooms.
View this unit
When the site is too cold to dry properly. This electric site heater delivers 20 kW and needs a 400 V three-phase connection. The heat speeds up drying; the dehumidifier removes the moisture itself.
View this unitIn Rebecq we deliver by appointment. You choose a delivery date when you book, and we call afterwards to agree the time. From Aartselaar the technician is on the road for almost an hour. Let us know in advance about a staircase without a handrail, a narrow hallway or little room to park. He places the units, connects them and shows you how to check the condensate drain.
If you only need one unit, you can collect it by appointment at Boomsesteenweg 12, unit 11 in Aartselaar. From Rebecq that is almost an hour's drive each way, and you make the trip twice: to collect and to return. Book in advance so the unit is ready, and check that it fits in your car.
Boomsesteenweg 12, Unit 11, 2630 Aartselaar
Mon–Fri 08:00–17:00, by appointment
Sites in Walloon Brabant, each with photos of the site itself. The same team, the same reading at the start and at handover.
The table helps you plan the hire period. A guide time does not confirm that the material is dry enough. The check before finishing is still needed.
| What needs to dry | Without a dehumidifier | With a Vernast drying package |
|---|---|---|
| Cement screed 5 cm | 6 to 9 weeks | 2 weeks |
| Cement screed 6 cm | 8 to 12 weeks | 3 weeks |
| Cement screed 7 cm | 10 to 15 weeks | 4 weeks |
| Plasterwork 1 cm | 1 to 2 weeks | 2 weeks |
| Plasterwork 2 cm | 2 to 4 weeks | 3 weeks |
| Plasterwork 3 cm | 3 to 6 weeks | 4 weeks |
The table gives guide values for planning. The actual drying time depends on the material and the conditions on site. Before finishing, have the residual moisture checked against the requirements of your floor layer or decorator. For calculated packages, free continued hire applies under the drying guarantee terms. How long screed needs to dry explains it case by case.
We deliver in Rebecq and the surrounding municipalities. Choose a place below for details on hire and delivery, or see our service area in Walloon Brabant.
Delivery to Beauvechain, Chastre, Chaumont-Gistoux and the other places below. Choose your municipality for details on hiring a dehumidifier.
From your request to collection. We agree the installation, explain how to use the units and follow the drying process with moisture readings.
Calculate your package online or call us for advice. Give us your site address, your preferred start date and the dimensions of the rooms.
At the agreed time the technician installs the units, connects the condensate drain and explains how to use them.
Use the set-up as the technician explained. Check the condensate drain and report any faults or new moisture problems.
We check the moisture and arrange collection. For calculated packages, free continued hire applies if the drying guarantee terms are met.
Read how customers experience Vernast's delivery, appointments and follow-up. These reviews are about our service across our whole service area.
“Snelle respons en dezelfde dag nog een droger geïnstalleerd. Top service!”
“Zeer goede service en flexibiliteit. Werken zijn uitstekend uitgevoerd. Vriendelijk personeel. Firma zeker aan te raden.”
“We zijn bijzonder tevreden. Het personeel is professioneel én vriendelijk. Het werk is grondig uitgevoerd. Bovendien werd het achteraf goed opgevolgd.”
Our drying experts will help you straight away, with advice tailored to your situation.
Put your drying package together online and choose a delivery date. We then call you to fix the delivery time. Include the full site address, the floor and who will let us in that day.
That depends on the mortar. Some screeds first need a few days to cure undisturbed before you force-dry them. Check with your screed contractor or the product's technical data sheet, and tell us the date it was poured.
Not from the surface and not from the number of hire days. A moisture reading in the core of the screed settles it. Your tiler or parquet fitter knows what value their material requires.
The 20 and 30 kW electric site heaters run on 400 V, so on three-phase power. A standard socket is not enough for them. If in doubt, have your electrician check whether the site distribution board can handle the load.
Yes, by appointment at our warehouse in Aartselaar. Allow almost an hour's drive each way. Book the unit in advance and follow the transport instructions you are given.
Installed and set up by our technician, with a moisture reading at the start and at handover. Prefer to talk it through first? Feel free to call us.

Briefly describe what needs to dry and how big the room is. A drying specialist will reply within one working day, with a proposal for the right package.